The 112IM Sub is a single 12” high output low frequency sub woofer sound reinforcement system.

The system utilizes an injection molded enclosure designed for use in direct weather applications. This product is intended for applications where additional low frequency acoustic output is required in conjunction with the 112IM or 212CIM One Systems enclosures.

The unique design of the 12 inch 12I/O woofer provides an excellent combination of high sound pressure levels and low distortion.

The ONE SYSTEMS 112IM Sub features a thick wall trapezoidal enclosure that utilizes internal structural supports and stainless steel rigging points to enable the enclosure to be used in a wide variety of permanently installed applications.

The grill is a 3 layer “rain shield” design that will minimize direct rain contact with the systems transducers. All internal and external rigging hardware, as well as the grill, are stainless steel. The enclosure and grill design are rated to IEC 529 IP45 (solid object penetration to 1 mm (0.04 inches) and water jets from any direction). The enclosures and components are also designed to Mil Spec 810.

The input section consists of both 4 pin Neutrik Speakons as well as a stainless steel hardware barrier strip. A weather cover is provided with an integral gland nut connec-tor for outdoor applications. In the outdoor configuration connections are made throughthe 4 position barrier strip. 
The gland nut is weather proof and is rated NEMA 6P (IP68). The connector will accommodate cable outside diameters from 7mm to 12mm (0.236” to 0.472”).

The maximum diameter will accommodate most 2 conductor AWG 12 cable 
assemblies. The low frequency design is patent pending. The 12 inch 12I/O woofer utilizes a unique voice coil wind on the inside of the voice coil support structure. This design allows for both high magnetic system displacement as well as increased thermal transfer. This results in reduced power compression and higher reliability.

An M10 forged shoulder eye bolt kit is available for all M10 suspension points. The system may be used with 112IM or 212CIM enclosure in both simple and “T” planar arrays using the FLY-112IM or FLY-112IM-T planar array kits. It may also be used with the Pole Mount System.

• Weather Resistant 12” Low Frequency System 
• Injection Molded High Weatherability Enclosure for Optimized Bass 
• Optimized for use with the 112IM and 212CIM 
• 1 x 12 inch 12I/O ONE SYSTEMS Woofer 
• Patent Pending Large Voice Coil Low Frequency Transducer 
• Multiple M10 Flying Points 
• Available Array Brackets Planar Arrays and Pole Mount System 
• Barrier Strip and Speakon Inputs with Gland Nut Weather Cover

Frequency Response:
50Hz – 150kHz

Coverage Pattern:
Essentially Omnidirectional

Active Crossover Frequency:
Recommended 80Hz (150Hz max)

Inputs:
4 position barrier or
2 each 4 pin Speakon

System Sensitivity: (1watt-1meter)
96dB

Power Handling:
800 watts Continuous
1600 watts Program
3200 watts Peak*

Nominal Impedance:
8 ohms

Low Frequency: 
ONE SYSTEMS 12 I/O (1 each)

Suspension/Mounting points: 
17 each M10

Weather Performance: 
IEC 529 IP 45
Mil Spec 810

Dimensions (H x W x D): 
749mm x 368mm x 399mm 
(29.5 in x 14.5 in x 15.7)

Net Weight: 
25 kg (55 lb)

Optional Accessories: 
FLY-112IM
FLY-112IM-T
M10 Forged Shoulder Eye Bolt

Additional Supporting Systems:
112IM
112CIM

* All power handling ratings are amplifier headroom dependent